Permabond 2011 Cyanoacrylate Surface Insensitive Gel

Permabond 2011 is a thixotropic, fast-setting cyanoacrylate particularly suitable for use on vertical and porous substrates. It offers high-temperature resistance, maximum gap filling capability, easy application, and is ideal for high-speed production lines.

Permabond 2011 Cyanoacrylate Surface Insensitive Gel

Categories Adhesives and Sealants, Cyanoacrylate Adhesives Brands: Permabond.

Permabond 2011 can be used on metals, plastics, elastomers, ceramics and wood.

Cyanoacrylate adhesives are single component adhesives that polymerize rapidly when pressed into a thin film between parts. The moisture adsorbed on the surface initiates the curing of the adhesive. Strong bonds are developed extremely fast and on a great variety of materials. These properties make

Permabond 2011 cyanoacrylate the ideal adhesive for high-speed production lines.

Application

Used for bonding vertical and porous substrates, metals, elastomers, plastics, wood, and ceramics.

Features

Thixotropic
Surface insensitive
Fast cure
Easy to apply and dispense
High-temperature resistance
Maximum gap filling capability

Hot Strength

Permabond 2011 can withstand higher temperatures for brief periods (such as for paint baking and wave soldering processes) providing the joint is not unduly stressed. The minimum temperature the cured adhesive can be exposed to is -55 °C (-65°F) depending on the materials being bonded.

Surface Preparation

Surfaces should be clean, dry and grease-free before applying the adhesive. Use a suitable solvent (such as acetone or isopropanol) for the degreasing of surfaces.
Some metals such as aluminium, copper and its alloys will benefit from light abrasion with emery cloth (or similar), to remove the oxide layer.

Directions for Use

Apply the adhesive sparingly to one surface.
Bring the components together quickly and correctly aligned.
Apply sufficient pressure to ensure the adhesive spreads into a thin film.
Do not disturb or re-align until sufficient strength is achieved, normally in a few seconds.
Any surplus adhesive can be removed with Permabond CA solvent, nitromethane or acetone.

NB: For difficult or porous surfaces using a Permabond activator is recommended. If bonding polypropylene, polyethylene, PTFE or silicone, prime first with Permabond Polyolefin Primer (POP).

Permabond 2011 Cyanoacrylate Surface Insensitive Gel