Permabond 3D90 Cyanoacrylate 3D Print Infiltrant

Features

• Ultra-low viscosity and delayed cure speed allows a good depth of penetration into parts
• Alkoxyethyl formulation is low odour and minimizes powdery white residue on surfaces
• Low odour makes it suitable for use in dip baths for large parts
• The solvent-free formulation helps minimise workplace hazard
• Adds extra strength and significantly improves printed part performance and durability
• Moisture cure mechanism – no need for measuring and mixing
• No curing equipment required
• Fills voids and porosities
• Easy to apply either as “on the spot” coating or in a dip bath
• Suitable for use on simple or complex, large or small parts
• Clear, colourless appearance
• Tack-free finish

Hot Strength

Surface Preparation

• Surfaces should be clean, dry and grease-free before applying the adhesive. Use a suitable solvent (such as acetone or isopropanol) for the degreasing of surfaces.

Directions for Use

FOR USE AS 3D PRINTING INFILTRANT

1. Coat or dip parts in Permabond 3D90
2. Allow adhesive ample time to soak in before removing. Hang parts to dry / drip off over a collection tray. Wet parts will bond to other surfaces they come into contact with so exercise caution.
3. Permabond CSA – NF low odour activator can be post-applied to cure liquid adhesive remaining on the surface if required.

FOR USE AS AN ADHESIVE

1. Apply the adhesive sparingly to one surface.
2. Bring the components together quickly and correctly aligned.
3. Apply sufficient pressure to ensure the adhesive spreads into a thin film.
4. Do not disturb or re-align until sufficient strength is achieved, normally in a few seconds.
5. Any surplus adhesive can be removed with Permabond CA solvent, nitromethane or acetone.